Aftermarket pickup rings don't fit late 90's Jackson ring screw holes

[Julz]

If you have access to a 3D printer or 3D printing service, download this and print all the rings you want. It's an oversize Jackson ring with a standard humbucker cavity.

http://www.123dapp.com/123D_Design/J...Marzio/5538946

[Administrator]

Using my digital calipers, looks like the center to center screw hole spacing on the guitar is around:

Width = 37.3mm
Length = 83.1mm

Was thinking of ordering these to see if they work as according to the measurements, they are really close:

http://guitarelectronics.com/humbuck...bottoms-black/

Width = 38.1mm
Length = 82.55mm

[vector]

If they're plastic rings, find a belt sander and very carefully sand the bottom edge down to a more suitable angle. I've done it with excellent results. Just watch out for the occasional accidental fingertip zap.