If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
What are the specs of that red string-thru XTRR again? More pics, please!
Hey Joe - it has a flamed maple centre section, with I think either mahogany or Korina wings. It's 24 3/4" scale, rev sharkfins, the flame top is about 1/2" thick, there's a push pull on the volume for switching, ebony buttons on the tuners, custom Duncan and DiMarzio with gold polepieces and it's been signed on the rear of the head by Delores Rhoads (shame my name's not Michael though!) That's about all the specs I can come up with right now
I need to get a old RR type bridge from Dave, and have wondered about removing the V-plate and going for ferrules, but I doubt I'll ever get round to it! The pics suck, but here they are:
Popular is not the same as good
Rare is not the same as valuable
Worth is what someone will pay, not what you want to get
I also dig that ESP next to it. Was that a custom order, mutt or what?
That's an older one that's been modded with a Floyd. It has a single hum route under the guard. I don't know much about it, other than that. I think it's an 'original' guitar though, rather than a mutt....
Popular is not the same as good
Rare is not the same as valuable
Worth is what someone will pay, not what you want to get
Hey Joe - it has a flamed maple centre section, with I think either mahogany or Korina wings. It's 24 3/4" scale, rev sharkfins, the flame top is about 1/2" thick, there's a push pull on the volume for switching, ebony buttons on the tuners, custom Duncan and DiMarzio with gold polepieces and it's been signed on the rear of the head by Delores Rhoads (shame my name's not Michael though!) That's about all the specs I can come up with right now
I need to get a old RR type bridge from Dave, and have wondered about removing the V-plate and going for ferrules, but I doubt I'll ever get round to it! The pics suck, but here they are:
Awesome. Is that a Feiten tuning system or some kind of other compensated nut on there?
I feel my soul go cold... only the dead are smiling.
Funny, my room just went thru a revamp. Big office desk in here now, yet more space for guitars. And today is payday.... now if I could just up my USA Jackson count to 3...
Fuck ebay, fuck paypal
"Finger on the trigger, back against the wall. Counting rounds and voices, not enough to kill them all" (Ihsahn).
Thanks guys - it'd be great to get the guitars that are still back in the UK over here, but that's not really too practical right now....
Ah well, why didn't you say? I'd be only too pleased to look after the guitars left here, make sure they get the love and attention they deserve. I'd even wipe my "special polish" off afterwards.
I need to get a old RR type bridge from Dave, and have wondered about removing the V-plate and going for ferrules, but I doubt I'll ever get round to it!
I may be in the minority, but I dislike v-plates. I was wondering what you'd have planned to do to disguise the three screw holes where the v-plate is attached?
Comment