Announcement

Collapse
No announcement yet.

HELP!!! Wiring config

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • HELP!!! Wiring config

    Okay, I'm putting back the EMG HZ in a 1 HB p'up guitar with 1 volume and no tone pot. Have pulled up conflicting wiring schematics. EMG says no cap needed (there was none when I took it out to put in a EVH) where as others have shown it. Never used a cap on a single hum, no tone config. What's up?
    Hum-1Tone.jpgemg6x.jpg
    Last edited by vector; 08-29-2012, 08:39 AM.

  • #2
    The diagram looks to be redrawn or something. I would use a different one.
    I want to go out nice and peaceful in my sleep like my grandfather, not screaming and hollering like the passengers in his car.

    Comment


    • #3
      I figured it out. What was throwing me off was the missing bit between the lug where the input jack ground attached and the pot bottom. Diagram shows that it is just soldered together rather than joined by a bit of wire. So I did the same and works great!

      Comment

      Working...
      X